Perception

Perception was a wall piece.  28″ by  12″

I made the design in paper. I numbered each section and I transferred to a thick plastic to put on the clay. After I used the slab roller to make the tile. For this project I used a thick surface, laminate plywood 1.5 “, covered in plastic. When I put the clay on top I covered the borders too.

I tried to keep the borders in place using foam tape and plastic strips around the piece. I think next time I would like to use a ratchet tie down.

I fired cone 04

I glazed and fired cone 04

 

I used a little brown grout in the frame.

Leave a Reply